Zellabox Cubb, Руководство по установке

Страница: 22 / 23

22
2. Follow Pyrorack Commissioning steps
from the installation manual.
3. Populate the Micro Data Centre with your
critical equipment and add equipment labeling
in PDView.
NOTE: Ensure adequate gaps are left between
the equipment housed within the Micro
Data Centre to ensure an effective air-flow is
maintained. The cooling system will maintain
the optimal cooling air-flow between the
equipment if this recommendation is adhered to.
NOTE: DO NOT exceed the cooling system’s
recommended BTU/h specifications (listed
in the cooling system section) as this will
overheat the equipment.
The Zellabox Micro Data Centre is a PLUG N
PLAY unit therefore once it has been installed
by a qualified contractor the Micro Data
Centre is ready for use!
1. Follow these steps to start up your unit:
•
Start-up the switchboard
•
Switch Mains Isolator switch to the ON
position
•
Switch Cooling System switch to the ON
position only when the cooling system has
been commissioned . Leave in the OFF
position until the air con contactor has
installed.
•
Switch UPS switch to the ON position
•
Switch all remaining switches to the ON
position
Zellabox
Start-up procedure
8 Start-up and ready for population
REFER TO USER MANUAL FOR FURTHER INFORAMTION