Zellabox Cubb, Руководство по установке

Страница: 13 / 23

5.5 Start up Procedure – Single Cooling ( Cubb)
1. ONLY once the condenser has been hardwired and copper piping
connected can the cooling system be turned on.
2. Insert cooling system IEC plug (orange cable) into the cooling system
socket at the rear of switchboard labelled (Cooling system).
3. Ensure switchboard is powered and both the Cooling System RCD
and Cooling System are in the
ON position
4. Start-up cooling system on remote located at the back door on
left hand side .
5. Press the START button on the cooling system remote.
6. Ensure temperature is set to 23° on cooling mode and FAN
STRENGTH is on HIGH.
7. Installation complete
5.6 Start up Procedure – Dual Cooling ( Cubb)
1. ONLY once the condensers have been hardwired and copper piping
been connected can the cooling system be turned on.
2. Insert cooling system (IEC) plugs (Orange cable) into:
3. Plug Orange Cable (Labelled – Cooling system 1) into Permanent
supply 1
4. Plug Orange Cable (Labelled – Cooling system 2) into Permanent
supply 2
5. Ensure switchboard is powered and both the Cooling System RCD
and Cooling System are in the
ON position
6. Start-up cooling system on remote located at the back door on
left hand side.
7. Press the START button on the cooling system remote.
8. Ensure temperature is set to 23° on cooling mode and FAN
STRENGTH is on HIGH.
9. Run both system together for 5 minutes – ensure both systems are
operating.
10. Pull out both plugs without turning cooling system off from the
permanent supply and plug into Cooling systems 1 & 2 outlets.
11. One system will be operation following this step.
12. Installation complete
Zellabox
Safety Instructions
7
Name of Parts
Remote Controller
Signal transmitter
Receiver
To use the remote controller, aim the 4
transmitter at the indoor unit. If there
is anything to block signals between
the unit and the remote controller,
such as a curtain, the unit will not
operate.
Do not drop the remote controller. Do
4
not get it wet.
The maximum distance for
4
communication is approx. 7m.
FAN setting button
It selects the air  ow rate setting. 4
Page 14
POWERFUL button
POWERFUL operation. 4
Page 17
Display (LCD)
It displays the current settings. 4
(In this illustration, each section is
shown with all its displays on for the
purpose of explanation.)
TEMPERATURE
adjustment buttons
It changes the temperature setting. 4
Page 12
ON/OFF button
Press this button once to start 4
operation.
Press once again to stop it.
Page 11
Front cover
Open the front cover. 4 Page 8
HEAT PUMP model ARC452A4
COOLING ONLY model ARC452A13
01_EN_3P291209-1.indd 7 01_EN_3P291209-1.indd 7 12/8/2011 9:18:00 PM 12/8/2011 9:18:00 PM
Mechanical Diagram
Model Number: PX3-5092R-F8 4
Cooling Remote
C
o
o
lin
g
Syst
e
m
1
C
o
o
lin
g
Syst
e
m
2
Pe
rma
n
e
n
t
Su
p
p
ly
1
Pe
rma
n
e
n
t
Su
p
p
ly
2
5 Single & Dual cooling system commissioning steps:
13