Zeiss OPMI 1FR XY, Инструкция по эксплуатации

Страница: 50 / 114

50
Description
G-30-1416-en OPMI® 1FR XY Surgical Microscope on S7 Floor Stand Issue 4.0
Printed on 14. 11. 2007
Connector panel
1 Connector for switching component
Connection possibility for: a foot control panel, a hand control panel or
an operating chair with an appropriate foot switch.
2 Potential equalization pin
3 Indicator window for rated voltage
The voltage shown here must correspond to the rated voltage pro-
vided on the site of installation. You can adjust the sliding switch using
a suitable tool.
Warning!
Please observe the maximum current consumption of two power outlets
(4) and (5). Only connect medical devices approved by Carl Zeiss to out-
lets (4) and (5). When using other instruments, make sure that safety is
guaranteed regarding admissible ground leakage currents. The admis-
sible limit value of the ground leakage current present in the stand's power
cord must not exceed 500 µA in compliance with EN60601-1/IEC 601-1.
The CSA NRTL certification in compliance with UL 2601-1 only allows a
maximum ground leakage current of 300 µA.
4 Power outlet
for medical devices with a current consumption of max. 2 A.
Note:
The current of this power outlet is switched on and off using the power
switch of the stand.
5 Power outlet
for medical devices with a current consumption of max. 5 A.
6 Power inlet
7 Strain relief device
The strain relief device prevents inadvertent unplugging of the fol-
lowing electrical connections:
– power cord,
– connecting cable for foot control panel, hand control panel or op-
erating chair with appropriate footswitch.