OPERATION
Carl Zeiss
Switching on the control unit
Colibri.2
22
423052-7244-001
07/2014
4
OPERATION
4.1
Switching on the control unit
•
Switch the Colibri.2 illumination system on/off
by means of the ON/OFF switch
Power
(Fig.
4-1/
1
) at the front of the control unit.
As soon as the pilot lamp integrated in the switch
is illuminated, the lamp module is ready for
operation.
4.2
Functions of the control panel
The control panel is used to control the LED
modules, to switch over to the white light source,
and to check the shutter of the HXP 120 V.
When switching on the control unit, the system
will be initialized, the LED modules present in the
lamp module will be identified by ACR (automatic
component recognition) and indicated on the 4-
line display (Fig. 4-2/
1
and Fig. 4-3/
1
, respectively).
In addition, the intensity for each LED module will
be shown in percent and the switching status
ON
and
-
(for OFF) is indicated.
The LED modules are individually switched on/off
by pressing the control elements
1
to
4
(Fig. 4-2/
5
)
down. These control elements are also used to
regulate the intensity by pushing them in the
direction of the display or in the opposite direction.
The set brightness will remain temporarily stored
even after switching off the respective LED module
(i.e. unless the control unit is switched off). When
this LED module is switched on again, it will
illuminate with the same brightness as it did before
it had been switched off.
To switch off all LED modules at the same time,
press the
All off
button (Fig. 4-2/
2
).
The
Ext.
button (Fig. 4-2/
3
) is used to switch the prism to the external white light source, and the
Shutter
button (Fig. 4-2/
4
) functions to open/close the shutter of the white light source HXP 120 V. If
another white light source is used, the
Shutter
button will have no function.
Fig. 4-1
Control unit
Fig. 4-2
Control panel, with lamp module
being controlled
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
