Assembly Instructions
Place radiator in desired location and mark out position of holes on wall near top & ends of radiator.
Drill 10mm diameter holes in wall to a minimum depth of 65mm and insert wall plugs (A).
Screw brackets (B) into wall using screws (C).
Loosely fit clamp assemblies (D) onto radiator tubes.
Place radiator in position and locate clamp assemblies (D) into the slots in the brackets (B).
Tighten up clamp assemblies (D) and fix security clip (E) over clamps (C).
Electric radiators should be fitted only by a qualified electrician and must be connected to a cable outlet in the bathroom
in accordance with I.E.E. wiring regulations. The electrical connection should be made to a ‘13 amp fused fixed spur’
located outside the bathroom.
Note: for maintenance purposes, cable outlets must remain accessible and cables must not be buried directly into walls.
FITTING INSTRUCTIONS
Wall plugs - 10mm
Screws - 7mm diameter x 60mm length
Wall plugs - 10mm
Tape measure
Spanner - 13mm
Socketdriver - 10mm long reach
Electric drill
Masonry drill bit - 10mm diameter
Spirit level
Tools & Material Required
Electric Classic Radiator
A
E
B
C
D
A
2
B
2
C
2
D
2
E
2
Wall Plug*
Bracket
Clamp Assembly
Security Clip
Screw - Hex Head, 7mm dia x 60mm*
Key
Component
Qty
* Wall Plugs & Screws not supplied
Issue 9.1
© Bisque, a division of Zehnder Group UK Ltd
Wiring Guide
Brown - live
Grey/Blue - neutral
Black - unused (unless customer has a centrally controlled pilot wire system).
.
This wire should NOT be wired to earth under any circumstances
Caution:
To avoid overheating, this appliance must not be covered.
The control and thermostat must be kept clear at all times
