- 4 -
5.1.
Set NUMBER OF IGNITION CURVE POINTS
Move to
Nr. of Points
with pressing + or - and then press enter .
Now you can select number of ignition points, with pressing + or - and then press enter .
5.2.
Set PARAMETERS OF IGNITION CURVE POINT
Move to point you want to change, with pressing + or - and then press enter .
Now you can change rev point with pressing + or - (in 100 rpm steps) and then press
enter .
Now you can change advance angle with pressing + or - (in 0.1deg steps) and then press
enter .
6. Set
ADVANCE
With this setting is possible to advance or retard whole ignition curve. When setting is
positive then ignition curve is advanced and when setting is negative than ignition curve is
retarded. With
Advance
0.0deg
, ignition curve is unchanged.
Enter menu and move to
Advance
with pressing + or - and then press enter .
Now you can set advance with pressing + or - (in 0.1deg steps) and then press enter .
7.
Set SHIFT LIGHT
Enter menu and move to
Shift Light
with pressing + or - and then press enter .
Now you can change rev point with pressing + or - (in 100 rpm steps) and then press
enter .
8.
Set SHIFT KILL TIME
Enter menu and move to
Shift Kill Time
with pressing + or - and then press enter .
Now you can change kill time with pressing + or - (in 10 ms steps) and then press enter .
9.
Set REV LIMIT
Enter menu and move to
Rev Limit
with pressing + or - and then press enter .
Now you can change rev limit with pressing + or - (in 100 rpm steps) and then press
enter .
10.
Set STATIC ANGLE
Enter menu and move to
Static Angle
with pressing + or - and then press enter .
Now you can set static angle with pressing + or - (in 0.1deg steps) and then press enter .
More information's about static angle you can find in section 22.