19
20
(The ROKER(HOVER THROTTLE) provides proportional trim function, while the
AUX2 channel allows the switch of 2 or 3 positions. Or you can inhibit the AUX2
rocker as well to prevent inadvertent changes. You can also choose the rocker as
an AUX2 channel proportional outputing. )
In addition, you have 3 choices to activate/inhibit FLAP SYSTEM:
●
System (3-position switch)
●
Rocker
●
INH
(The ROKER(HOVER THROTTLE) provides proportional trim function, while the
AUX2 channel allows the switch of 2 or 3 positions. Or you can inhibit the AUX2
rocker as well to prevent inadvertent changes. You can also choose the rocker as
an AUX2 channel proportional outputing. )
◆
Wing Type
In the fixed wing mode, the 7AH-2400 offers three different wing types to choose
from: Normal, Flaperon and Delta. In addition, V-Tail mixing is available from the
Wing Type screen.
◆
Normal
When the Flaperon and Delta wing function are off, Normal wing type is selected.
Use this wing type with common aircraft that utilize only one servo for both ailerons.
Normal is the default setting.
◆
Flaperon Wing Type Selection
Flaperons require the use of one servo for each aileron and allow the use of
ailerons as flaps or spoilers. This function also allows the precise independent
adjust of up and down travel, and independent sub-trim and differential of each
aileron.
◇
To Access Input Select
Press the DOWN and SELECT keys simultaneously, then turn on the transmitter.
Press the UP key until the INPUT SELECT function appears on screen.
Here you have 4 choices that can be used to operate auxiliary channel :
●
2-position switch
●
3-position switch
●
Rocker
●
INH
◆
Delta Wing Type Selection
Delta wing arrangements combine the function of ailerons with the function of the
elevator to allow precise control of both roll and pitch.
[
SKMODE
SELECT
]
MODE
1
ELEV
RUDD
THRO
AILE
◆
Input Select
The purpose of the Input Selection Function is to assign the activation device for
the AUX2 channel and the FlAP Channel.
Change Pole mode
From Main Screen Display press the DOWN and SELECT keys simultaneously to
enter thFunction Mode.
Press the DOWN and SELECT keys simultaneously, the turn the transmitter on.
Press the UP key until SKMODE SELECT appear on green.
Press the INCREASE and DECREASE keys to change the pole mode.
。
◆
Channels Distribute
The T7AH-2400 can assign 7 channels to output in any channel, you can choose a
different style of the channel allocation, can also customize the output channel
allocation output.
[
CHNO
ASSGIN
]
1
:
THRO
2
:
AILE
3
:
ELEV
4
:
RUDD
5
:
GEAR
6
:
FLAP
7
:
AUX2
[
INPUT
SELECT
]
AUX2
TRIM
:
INH
FLAP
:
SYSTEM
Press
to
enter INPUT
SELECT
Hold
while
turning
on
the
transmitter
FLAP
TRIM
:
INH
INCREASE and DECREASE key
AUX2
:
2P
SW
GEAR
:
2P
SW
Change the channel distrubute
Press the SELECT and DOWN keys simultaneously and turn the transmitter on.
Press the UP key until CHNO ASSGIN appears on screen.
Press the SELECT key to select channel that you wish to output signal.
Press the INCREASE or DECREASE key to change the signal out putted by channel.
Press the CLEAR key restoring default values.
