Solo documento principale.
Ident
ific
at
ion:
M
D
-AL
-GI
-00
R
ev
. 4
.0
of
31.
01.
18
-
Appl
ic
at
ion
: G
ID
Pile Reg. IT12110P00002965 -
Share Capital € 100,000.00 fully paid up
AR Bus. Reg. no. 03225010481
– AR REA no. - 94189
Certified Company ISO 9001 - Certificate no. 9151 - CNS0 - IT-17778
Zucchetti Centro Sistemi S.p.A. - Green Innovation Division
Via Lungarno, 248 - 52028 Terranuova Bracciolini - Arezzo, Italy
tel. +39 055 91971 - fax. +39 055 9197515
[email protected] - [email protected] -
zcsazzurro.com
Manual of 25/08/2020 Rev. 1.2 “User Manual 7000-BE-24”
7/43
1.
Preliminary safety instructions
If you have problems or questions in reading and understanding the
following information, please contact Zucchetti Centro Sistemi S.p.A.
through the appropriate channels.
Note
1.1.
Safety instructions
Highlights the safety instructions to be followed during installation and use of the equipment.
Before installing and using the equipment, make sure you read and understand the instructions in this
manual and familiarise yourself with the relative safety symbols shown in this chapter. According to
national and local requirements, permission must be obtained from your local provider before
connecting to the electrical grid, making sure that the connections are carried out by a qualified
electrician. All installation work must be carried out by a qualified and competent electrician.
Contact the nearest authorised service centre for any repairs or maintenance. Contact your distributor
for information on the nearest authorised service centre. DO NOT carry out repairs yourself, as this may
result in injury or damage.
Qualified personnel
Ensure that the operator has the necessary skills and training to operate the equipment. Personnel
responsible for use and maintenance of the equipment must be qualified and capable of performing the
activities described, and must also have appropriate knowledge on how to correctly interpret the
contents of this manual. For safety reasons, this charging station can only be installed and serviced by a
qualified electrician with the necessary training and/or skills and knowledge. Zucchetti Centro Sistemi
S.p.A. declines all responsibility for damage to property or personal injury caused by incorrect use of the
device.
Do not attempt in any way to repair or replace components of the charging station without the
assistance of qualified personnel.
Installation requirements
Install and start the charging station according to the following instructions. Place the charging station
on suitable load-bearing supports with sufficient load capacity (such as metal walls or columns) and
make sure it is positioned vertically. Choose a suitable location for the installation of the electrical
equipment. Make sure there is sufficient space for heat dispersion and to accommodate future
maintenance. Maintain adequate ventilation and ensure that there is enough air circulation for cooling.
