4
Need help?
www.zBoost.com
Tech Support
877-594-5766
Mon.- Fri. Hours: 8:30 am to 5:30 pm EST
magnet base of the antenna to the
fl
at
surface of the bracket. The antenna must
be mounted vertically for the best signal.
2.
Install the Mounting Bracket and zBoost
Mobile1.
Put your zBoost Mobile1 in the Mounting
Bracket (see instructions under Vehicle
Installation) and place it in a convenient
location such as a desk or table top in the
room where you will use the phone. The
location should be at least three feet from
the Outside Antenna to avoid oscillation
(feedback). Your cell phone must be in the
cradle for the zBoost Mobile1 to amplify the
signal. Use a Bluetooth headset, wired hands-
free device or speakerphone for talking on the
phone.
3.
Attach the antenna to the zBoost Mobile1.
Connect the cable from the Outside Antenna
to the antenna connector on the bottom of
the zBoost Mobile1. Do NOT plug in the
power supply (next step) until the Outside
Antenna cable is connected to the zBoost
Mobile1.
4.
Power up your zBoost Mobile1. Connect
the power cable to the mini-USB port on
the bottom of the zBoost Mobile1. Then
insert the adapter into the AC power supply
(859969), sold separately. Use only the
supplied zBoost power supply.
6.
Power up your zBoost Mobile1. Connect
the power cable to the mini-USB port on
the bottom of the zBoost Mobile1. Then
insert the adapter into the vehicle 12V DC
power source. Use only the supplied zBoost
power supply. While the zBoost Mobile1
may remain on, leaving the zBoost Mobile1
on in a vehicle when it is not running may
discharge the battery in a day or two. Also
note that some 12V DC power sources
are shut down when the vehicle ignition is
turned to off. Use a Bluetooth headset, wired
hands-free device or speakerphone for talking
on the phone.
In-Building Installation Option
Note: Indoor Accessory Kit ZB246 sold separately
1.
Install the Outside Antenna to a window. For
best results:
• Select a window on the side of the
building where you get the strongest cell
signal.
•
Attach the suction cup bracket (sold
separately) to the inside of a window so
the cable will reach the location of the
Mounting Bracket and zBoost Mobile1.
Place the bracket as high on the window
as possible.
NOTE: Many modern energy ef
fi
cient dual
pane windows use a metal coating that may
decrease the strength of a cellular signal,
reducing the effectiveness of the zBoost
Mobile1. If you have dual pane windows,
consider a zBoost signal boost product that
provides an option for mounting an antenna
on an outside wall or roof of a building.
• With the bracket in place, attach the
