Zaxcom RX-12R Rear
5
Rear
1.
RF In Antenna - A and B (50 Ohm BNC)
2.
RF Out Antenna - A and B (50 Ohm BNC) -
The antenna out is used to feed additional receivers. Please note
the antenna outputs adds 6dB of gain and is post the bandpass filter.
3.
Redundant power input (4 pin Hirose) with LED indicator -
The RX-12R will seamlessly switch to the input
with the highest voltage. The LED will illuminate when the RX-12R is receiving externa DC power.
4.
Analog out 1 thru 6 (XLR)
-
These connectors will output analog audio of the A side of the receiver modules.
5.
Main AES output (DB25)
-
This connector will output AES audio of both the A and B receiver for each module.
6.
Power switch
7.
ZaxNet communication connector (TA5) -
This connector is used to interface with an IFB200 to send ZaxNet
remote control commands to the transmitters.
8.
USB connector (Standard USB type A cable) -
Used to connect the RX-12R with a PC or Mac that is running
Zaxcom wireless monitoring software. Please note the USB connector cannot be used simultaneously with the
RS422 connector.
9.
RS422 connector (see wiring diagram) -
Used to connect the RX-12R to a Nomad or Oasis Please note the
RS422 connector cannot be used simultaneously with the USB connector.
10.
AES and Analog out (DB25)
-
This connector will output analog audio of the B side of each QRX212 module
outputs (7 thru 12) when the module is set to analog. When the module is set to output AES this connector
will output an AES signal of both the A and B receiver. Please note to output AES the RX-12R will need to have
the optional AES combiner board installed (not currently available).
1 2 3 4 5
6 7
8 9 10
