Zaxcom RX-12R Firmware Update
21
How to update the firmware for the QRX212 modules using a Zaxcom transmitter
1.
Insure that a stable power supply is connected to the RX-12R.
2.
Set the frequency on all the receiver modules to the same frequency that the transmitter that is being used
to send the firmware is set to.
3.
Confirm that the encryption code is set to off on the RX-12R and the transmitter.
4.
Go into the QRX program menu on the RX-12R.
5.
Press the star key, each QRX212 module should then display that it is “WATTING” for firmware.
6.
Insert the micro SD with the program file (QR2-XXX.BIN) in the programing transmitter.
7.
At the transmitter:
Make sure the transmitter has fully charged batteries installed.
Proceeded to the send QRX program menu.
Press the INC key.
The TRX will indicate that it found the program on the card and has started sending it.
8.
When the program file is being received by the RX-12R and the QRX212 modules are receiving the program
file, the sectors will start counting up.
9.
When each module is updated “SUCCESS” will be displayed.
10.
If a module does not receive all of the sectors wait, the transmitter will begin resending the firmware again
on its own, and will continue to transmit until manually stopped.
11.
When all the modules are updated you may stop the transmitter.
12.
Power cycle the RX-12R and confirm that each QRX212 module is running the updated firmware.
