Zaxcom RX-12R System Menu
9
Receiver Configure Menu
The receiver configure menu is where each of the 6 QRX212 receiver modules are
set up from. Once in the receiver configure menu individual receiver modules can
be accessed by pressing the corresponding number key on the numeric keyboard.
In each receiver configuration menu the status of each transmitter will be shown.
This is the same configuration that is in the home screen.
RX Mode
From the RX mode each individual QRX212 module can be set to single or dual mode and can be powered off.
Mode
Single - The QRX212 module is set to receive a single transmitter.
Dual - The QRX212 module is set to receive signal from two transmitters
Power
The power to each QRX212 module can be toggled on and off from the power setting.
Frequency
This is where the frequency of the QRX212 is manually adjusted from. To set the frequency highlight the
receiver that will be adjusted, then rotate the menu encoder knob, or press the desired frequency on the
numeric keypad.
Transmitter Gain
If the RX-12R is connected to an IFB200 the gain for each transmitter can be remotely adjusted from here and
will be sent over ZaxNet to the transmitters.
Unit Code
This is where the ZaxNet unit code for each module is set. The unit code on each QRX212 receiver must match
the unit code set in the corresponding transmitter for the remote frequency and gain commands to be sent to
the proper transmitter. Each receiver and transmitter pair must have its own unique unit code. The unit code
number can be set to any number between 1 and 99.
Output Type
The output type sets what audio signal the individual QRX212 module will output. Each module can be set to
output audio as either an analog signal or an AES signal. This setting will determine what is outputted on the
bottom DB25 connector “AES AND ANALOG OUT”. If this is set to analog the DB25 will output the b side of each
receiver QRX212 receiver module. If this is set to AES, when used with the optional combiner board (not
currently available) the DB25 will mirror the top DB25 connector.
Tone
Each QRX212 module has its own tone generator. Turning tone on will output tone from the TA5 connector
at -20dBFS allowing for the levels to be calibrated at the mixer or recorder.
