Zaxcom Nomad User’s Manual_____________________________________________________Chapter 2
53
Burn Bootloader page
Page purpose:
This page is responsible for starting the unit up, executing the main program, and burning the main
program when the user holds the STAR key on boot up.
How to get here:
(
MENU
knob
once
ENG Setup
button
Advanced Setup
button
Burn Boot Loader
button
)
Figure 2-60 Burn Bootloader page
NOTE:
The user should read the release notes whenever he installs a new version to see if he should install a
new bootloader or new ZaxNet firmware.
ZaxNet Setup page
Page purpose:
This page configures the wireless transceiver installed in Nomad.
How to get here:
(
MENU
knob
once
ZaxNet Setup
button
)
Figure 2-61 ZaxNet Setup page
Page Notes
For this page to useful, the following must be true for the associated wireless kit(s):
Zaxcom unit(s)
Transmitters must be TRX9xx units
Receivers can be any unit but prefer QRX100
Each TRX9xx must have a local recorder with recording media installed.
IFB Mode button
This button controls how the unit will operate on ZaxNet:
OFF
– the transceiver unit is not available for use
RX
– the transceiver is set to receive mode. The unit will function as any or IFB receiver.
TX
– the transceiver is set to transmit mode. The unit will be the master for units with its Group ID.
CAUTION:
If you set the IFB Mode button to TX, be sure to attach an antenna. If you don’t, RFI WILL get into
the mic preamps.
TX Channel button
This button controls which frequency the unit will use to transmit/receive.
