Zato CAYMAN FCE II Series, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 89 / 96

89 / 96
CAYMAN
Version 01 - Revision 00
09/05/2017
problem Cause solution qualification required
The attachment does not
cut the material�
The material dimensions
exceed the attachment
capacity�
Contact the Manufac-
turer for information on
the attachment cutting
capacity�
Mechanical Technician
The main blades are
excessively worn�
Replace the main blades,
refer to
“7.2.3.3 repla-
cing the main blades” on
page 74 ;
Mechanical Technician
There is excessive clea-
rance between the bla-
des�
Check the clearance
between the blades, refer
to
“7.2.2.5 Checks on the
shears” on page 64 �
Mechanical Technician
There is excessive
counter-pressure on the
hydraulic cylinder return
side� Check the main control
valve of the machine by
referring to the machi-
ne’s manual�
Mechanical Technician
The attachment does not
perforate the material� The razor blade is exces-
sively worn�
Replace the razor blade,
refer to
“7.2.3.6 repla-
cing the razor blade” on
page 79 �
Mechanical Technician
The upper jaw speed is
less than the parameters
originally set or is moving
in jerks�
The speed valve is not
working properly�
Replace the speed valve�
Manufacturer's Techni-
cian�
The oil flows coming from
the machine are irregu-
lar� Check the flow rates of
the machine by referring
to its manual;
Mechanical Technician
The material gets stuck
in the jaw of the at-
tachment�
There is excessive clea-
rance between the bla-
des�
Check the clearance
between the blades, refer
to
“7.2.2.5 Checks on the
shears” on page 64 �
Mechanical Technician
The main blades are
excessively worn�
Replace the main blades,
refer to
“7.2.3.3 repla-
cing the main blades” on
page 74 ;
Mechanical Technician
The upper jaws are
excessively worn�
Replace the upper jaws
by referring to
“7.2.3.10
replacing the upper
jaws” on page 84 ;
Mechanical Technician
There is excessive clea-
rance between the upper
jaws and the guide bla-
des�
Check the clearance
between the upper jaws
and the guide blades,
refer to
“7.2.2.5 Checks
on the shears” on page
64 �
Mechanical Technician