Zanussi ZTK123, Руководство пользователя

Страница: 20 / 64

carpets, strips of wood or similar. This might
cause heat built-up which would interfere
with the operation of the appliance.
Important!
• The hot air emitted by the tumble dryer can
reach temperatures of up to 60°C. The ap-
pliance must therefore not be installed on
floors which are not resistant to high temper-
atures.
• When operating the tumble dryer, the room
temperature must not be lower than +5°C
and higher than +35°C, as it may affect the
performance of the appliance.
• Should the appliance be moved, it must be
transported vertically.
• The appliance must not be installed behind
the lockable door, a sliding door a door with
a hinge on the opposite side to that of the
appliance in such a way that a full opening of
the dryer is restricted.
Removing transport safety packaging
Caution! Before use all parts of the
transport packaging must be removed.
1. Open loading door 2. Pull off adhesive
strips from inside ma-
chine on top of drum.
3. Remove foil hose and polystyrene padding
from the machine.
Electrical connection
Details on mains voltage, type of current and
the fuses required should be taken from the
type plate. The type plate is fitted near the
loading aperture (see “Product description”
chapter).
Warning! The manufacturer declines any
responsibility for damage or injury through
failure to comply with the above safety
precautions.
Should the appliance power supply cable need
to be replaced, this must be carried out by our
Service Center.
Warning! The power supply cable must
be accessible after installing the machine.
Door reversal
To make it easier to load or unload the laundry,
the door can be reversed.
Warning! The door must only be
reversed by an authorised service
engineer.
Please contact your local Service Force Cen-
tre. The engineer will carry out the door rever-
sal at your cost.
Special accessories
• stack kit
Available from your Service Force Centre
or your specialist dealer
These intermediate installation kits can be
used to arrange the dryer and an washing
machine (60 cm wide, front loaded) as a
space-saving washer/dryer stack. The wash-
ing machine is at the bottom and the dryer is
at the top.
Read carefully the instructions supplied with
the kit.
• drain kit
Available from your Service Force Centre
or your specialist dealer
Installation kit for direct draining of conden-
sate into a basin, siphon, gully, etc. The con-
densate tank then no longer has to be
20
www.zanussi.com