ZANTIA NARA PLUS 24, Руководство по эксплуатации и обслуживанию

Страница: 53 / 68

53 Mod. NARA PL. 24-34 rev 01
Instructions for use
translated from the original text
IT IT
FR FR
ES ES
EN EN
CHRONO PROGRAMMING Keys
After having selected your preferred program,
select the program time
P4 o
P6
Enter modify mode (the selected time flashes)
P3
Modify the times
P4 o
P6
Save the programming P3
Enable (a "V" is displayed) or disable (a "V" is not
displayed) the time slot
P5
Exit
P1
4.2.6 MANUAL LOADING / INITIAL LOAD MENU
The menu allows for the manual filling of the auger.
Press p3 to enter modify mode (the cursor flashes). Press keys
p4 and p6 to select the activation or deactivation of the auger.
Press p3 to confirm and p1 to exit.
The system must be switched off so that the operation
may be completed.
Note: when the auger is manually activated, the smoke ex-
tractor fan is also activated in order to close pressure switch
contact and subsequently power the auger.
4.2.7 RESET SERVICE
This menu allows you to reset the system maintenance ope-
ration message.
4.2.8 CUSTOMISATION MENU
Press and hold p3 for 3 seconds to access the customisation
menu. The menu is as follows:
MENU DESCRIZIONE
Keybo-
ard
Setting
Time and date Clock settings menu
Language Language change menu
Keybo-
ard
menu
Set contrast Menu to adjust the contrast
Set min light
Menu to adjust the lumino-
sity with the display inactive
Keyboard ad-
dress
Menu to set the RS485 node
address (the menu is only
available when enabled)
Node list
Menu to view the board
communication address,
board type and firmware
versions (the menu is only
available when enabled)
Acoustic alarm
Attivazione/Disattivazione
dell’allarme acustico
System
menu *
Menu to be accessed by service technician only
* Options only available on the local control panel
4.2.8.1 TIME AND DATE
Menu to set the current time and date. Press keys p4 and p6
to select the hours and minutes or the days of the week. Press
p3 to enter modify mode (the cursor flashes), use p4 and p6
to modify the selected data value. Press p3 to save the setting
and p1 to exit.
4.2.8.2 LANGUAGE
Menu to modify the language displayed on the control panel.
The selected language is that which is currently set.
4.2.8.3 SET CONTRAST
Use keys p4 and p6 to modify the contrast value, p3 to exit
and save and p1 to exit without saving.
4.2.8.4 SET MIN LIGHT
It allows you to adjust the display luminosity when the com-
mands are not in use.
Use keys p4 and p6 to modify the set-point value (minimum
0, maximum 20), p3 to exit and save the setting and p1 to exit
without saving.
4.2.8.5 KEYBOARD ADDRESS
Menu from which you can set the keypad as being local or
remote.
We recommend requesting that this configuration be perfor-
med at the service centre.
4.2.8.6 NODE LIST
Menu to view the board communication address, board type
and firmware versions.
4.2.8.7 ACOUSTIC ALARM
Menu to activate or deactivate the acoustic alarm.