How to apply
• Before attaching this product, carefully read through the "Precautions for use - Be sure to read this" section. Then follow the steps provided to
ensure the product is correctly attached.
• The steps below use the right leg for reference.
• These steps show how to apply EK-3. Use the same steps to apply EK-1 or EK-5.
1.
Place the center of the product at the back of your knee
with the correct side up. Straighten your knee and fasten
the upper hook-and-loop fastener B above your kneecap.
Position of
kneecap
Logo mark
Hook-and-loop
fastener B
2.
Fasten hook-and-loop fastener C below your kneecap.
Position of
kneecap
Hook-and-loop
fastener C
3.
Fasten hook-and-loop fastener A.
Hook-and-loop
fastener A
4.
Adjust hook-and-loop fasteners A, B, and C so that you
will be able to maintain an appropriate compression force.
5.
For EK-5 Only: Fasten the femoral cross straps at the
back of your thigh.
Femoral cross strap
For EK-5 Only
6.
Pull the product up and down to eliminate slack.
7.
Make sure that the product is not loose or incorrectly
attached. If you feel any discomfort, repeat the steps
from the beginning to reattach the product.
Disclaimer:
* The product specifications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specified by the local government.
* We take all possible measures to ensure product quality, however, if you find any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
“ZAMST” and “ZAMST logo” are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.
