12
6.
MAINTENANCE
6.1
ORDINARY MAINTENANCE ACTIVITIES (GENERAL INFORMATION)
For good maintenance:
-
use only original spare parts, suitable equipment for the task and in good conditions;
-
respect the frequency of interventions indicated in the manual for programmed maintenance
(preventative and periodic);
-
good preventative maintenance requires constant attention and continuous surveillance of the
machine. Immediately check the cause of eventual anomalies such as excessive noise,
overheating, leaking fluids, etc. and attempt to remedy.
In case of doubts, consult the constructor or the authorised assistance centre.
6.2
ORDINARY MAINTENANCE
To keep the machine running at full capacity, please follow the maintenance schedule as indicated.
The lack in conformity with the above exonerates the constructor from any and all responsibility in
respect to the guarantee.
NOTE: The indicated frequency refers to normal functioning conditions, i.e. it corresponds to
foreseen and contractually established working conditions.
TYPE OF OPERATION
FREQUENCY
START OF WORKING CYCLE END OF WORKING CYCLE
Safety devices control
X
Valves and pipes efficiency control
X
Clean the machine
X
Joint and soldering control
YEARLY
6.3
CLEANING THE MACHINE
Cleaning the machine permits the removal of eventual incrustations or deposits which may compromise
the optimal functioning of the machine and the processed product.
WARNING: All cleaning and maintenance interventions should be carried out only with
the machine disconnected from compressed air system.
WARNING: waste materials, such as oil, fat, inert material and whatever else should be
collected, recycled or disposed of according to the laws in force in the country in which
the machine is installed.
