CARE AND USE GUIDE
VACUUM INSULATED HYDRATION BOTTLES
GENERAL CARE
- Before first use, wash all parts with warm, soapy water. Rinse all parts thoroughly and allow time to dry.
- Contents should not be left in the container for longer than 24 hours. As soon as possible after each and every use, wash
all parts with warm, soapy water. Rinse all parts thoroughly with clean water. Allow all parts to dry completely prior to
next use or storage
- DO NOT use abrasive cleaners or scrubbers since they may dull the finish.
- DO NOT use bleach or cleaners containing chlorine on any parts of the product.
- This product is top-rack dishwasher safe; however, washing by hand is recommended as the dishwasher uses harsher
detergents and hot water that may affect the appearance of your product.
- Residual liquids, foods, or other contents may become trapped between product components, such as lid parts, container
parts, gaskets (flexible band around lid and/or stopper), or straws (if present in the product). Although this product is
top-rack dishwasher safe, hand washing is recommended to ensure that all parts of the product are thoroughly cleaned.
- For maximum thermal efficiency, preheat or pre-chill the product just prior to use. Fill with hot/cold tap water, attach lid,
let stand 5 to 10 minutes and empty water. After filling container with contents, re-cover with lid to increase thermal
efficiency. Never use a microwave, conventional oven, or other heat source for this purpose.
ASSEMBLY AND USE
HARD SPOUT LID WITH PUSH BUTTON AND SLIDE LOCK (IF PRESENT):
1. Remove lid (A) by twisting counterclockwise.
2. Unlock the slide lock (B) by sliding the lever to the “unlocked” position. Press the
push-button (C) on the lid (A) to open lid cover (D).
3. Pull out O-ring gasket (A1) from underside of lid (A) and spout gasket (D1) from
underside of lid cover (D).
4. Wash all parts separately and re-assemble. a. Ensure gaskets are properly seated
to minimize leaking.
5. Fill container with contents. Do not overfill: Leave space for lid (A)
to avoid overflow.
6. Replace the lid (A) by twisting it clockwise.
7. To drink, Unlock the slide lock (B) by sliding the lever to the “unlocked” position.
Push the button (C) located on the lid (A), which will release the lid cover (D) and
reveal the drink spout (E).
8. When finished drinking, close and lock the lid cover (D) by pushing the lid cover firmly down and lock the product by
switching the slide lock (B) to the “locked” position.
* Image for reference only: actual product may vary
A1
B
D1
D
F
C
A
E
