Zadako Z1, Руководство пользователя

Страница: 16 / 17

•
Double beep sounds, that indicates entry to diagnostics mode. Together with
that due to security reasons adequate alarm generates. (If you have telephone
numbers for alarm reports preset, Car alarm will send SMS messages and will
try to call).
•
During this mode will actual tests be cyclic indicated (reported) currently by
diode flashing and buzzer beep according to table (see chapter Signalization in
diagnostic mode).
•
Diagnostic mode is left by returning the key back to position 0
(disconnecting supply from „KEY“)
Signalization in diagnostic mode
After starting up the diagnostic mode Car alarm will start to check certain functions
and together with that report results of these tests. Signalization is formed of four
groups of synchronized consecutive flashes and beeps. At the beginning all tests are
active, that is why all four groups will be signalized. Certain groups are separated by
longer pause. End of signalization for certain group test is considered a correct
result.
Table of report groups :
Group
number
Number of
flashes /
beeps
Meaning of
group
Note
1 1x
Diagnostic mode
proceed Will be indicated until switch off KEY
2 2x
Test of data
connection with
server After successful testing data transmission
signalization of this group switches off
3 3x
Test of GPS
localization After reading GPS coordinates signalization of this
group switches off
4 4x
Test of RFID
reading device
After reading of any RFID tag signalization of this
group switches of.
This means, that it is necessary to attach RFID tag
to reading device.
If all tests run through correctly, only group one will stay cyclic signalized, which
means that Car alarm is still in diagnostic mode.
If another group, except group one, is signalized after a longer period (approx. 1
minute), it means that the test in that group found an error. In that case it necessary
to check this :
16