DOC-USR-0056-09
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
27
(5)
As soon as you select “z3_config1”, the screen will reload.
(6)
Change your desired settings.
(7)
Once your changes have been set in this configuration, click on the “Save” button.
(8)
If Local IP Settings have been altered, a window pops up reminding the user that, for changes to IP
Address / DHCP / Local Netmask / Default Gateway to take effect, a reboot is required. Click “Ok”.
(9)
A pop-up window appears to confirm the saving of these settings is complete. Click “OK”.
*Note:
The very first time settings are saved may take up to 30 seconds. This is due to some flash
initialization which occurs on the very first configuration save.
(10)
In order for these changes to take effect, the unit must be re-started. Power the unit off then back
on and wait 45-60 seconds for the unit to boot up.
(2) Select “z3_config1”
configuration
Figure 26 Selecting a Newly Created Preset
Click “Save”
(1) Click on “System Setup”
Figure 27 Saving New Settings to a User Preset
