36
DOC-USR-0264-02
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
13.17
Tuning for Latency
If streaming to the VLC media player, latency can be reduced on the decode side by adjusting the
network caching value. By default, this is set to 1000ms. You can lower this to as low as 200ms. To do
this, go to the following:
VLC
→
Tools
→
Preferences
→
Show Settings (ALL)
→
Input / Codecs
→
Network caching (ms)
13.18
Stream Multiple Resolutions
The Z3-FVXK-13A-RPS supports simultaneous encode into up to three different resolutions, bitrates and
output formats. Each output stream can be set using a separate channel tab. If the
CH2
tab is not
present, you can create a second channel by clicking on the
+
tab.
13.19
Record to Micro-SD Card
The Z3-FVXK-13A-RPS supports writing encoded video to a storage device connected to the Micro-SD card
in .ts or .mp4 file format.
(1)
Insert a microSD card into the microSD slot on the front of the unit.
*
Note:
The microSD card must be formatted in either FAT32, VFAT, EXT3, or EXT4 format.
(2)
If necessary, click on the “Stop” button in the lower right corner of the screen of the user
interface
CH1 tab.
(3)
Verify the settings under “Encoder Setup” match your video source.
(4)
Under Output Setup, set Output Format to “TSFILE”.
(5)
Using the Output Device dropdown menu, select your microSD storage location, such as
“/dev/mmcblk1p1”
.
(6)
In the “File Prefix” textbox, enter the desired prefix for your .ts file name.
(a)
When saved, a number will be automatically generated and added to the end of the file
prefix, starting with zero. If subsequent recordings are made to the same microSD card,
existing files with the same prefix will be detected and the new recordings will auto-
increment to the next number.
(b)
By default, “MOV” is entered. This will result in a file entitled MOV0.ts on the
microSD.
Subsequent recordings will be entitled MOV1.ts, MOV2.ts, etc.
Figure 27 Create Additional Output Channels
Click the “
+
”
Tab
