Yuwell M102, Инструкция по эксплуатации, Страница: 10 / 18

2). Open medication cup cover and then pour
out the remaining liquid.
3). Inject a small amount (2-5 mL ) of purified
water into medication cup and then tighten cup
cover. Shake medication cup gently to entirely
dissolve residual liquid in purified water.
4).Open dosing cover, pour out solution in the
cup and inject a small amount (2-5 mL) of
purified water again.
Remove the batteriesand pull out external power adapter prior
to cleaning and maintenance.
Since medication cup module is consumptive part, it is beyond
our warranty. In general, service life of medication cup is half a
year (three times or 30 min every day under normal tempera-
ture). The actual service life will vary with drug type.
Residual liquid, if hard to be removed, can be cleaned with
boiled hot water or for many times.
Clean residual liquid after using every day; if not, spray sheet of
nebulizer will be blocked and nebulization effect will be affected.
Cleaning mode is only used in spray sheet cleaning after
nebulization and should not be used in normal liquid inhalation.
2. Cleaning
1). Main unit: Wipe stains on main unit
gently with wet gauze; then wipe main
unit with new gauze to make it dry.
2). Clean electrodes on main unit and
medication cup module, so as to
ensure reliable connection between
medication cup module and main unit.
Attention
14 15
5). Press startup switch continuously until indicator LEDs flicker on
an alternate basis; at this time, nebulizer will enter washing mode
and spray out purified water, so as to remove residual liquid on spray
sheet.
Do not use volatile liquid (e.g. benzene, gasoline or diluent) to
wipe nebulizer.
The patient can't try to touch Mesh.
Do not deliberately touch electrodes on main unit and medica-
tion cup module with cotton swab or other articles, for fear of
electrode falling.
Remove batteries prior to parts cleaning. If power adapter is
used, pull off power adapter off from socket after powering off.
3). Medication cup module and
inhalation device: Wash medication
cup module and inhalation device
with purified water.
4). Wipe cleaned part with new
gauze and place the part in clean
place to fully dry it in the air.
Attention