Revised 04-08-10
YUNCA Leedz FS Fuzzy Feb 2010
Page 13 of 19
MAINTENANCE
(cont).
The following procedures should be performed only by a qualified service person. The
gas supply and electrical power should be isolated whenever any maintenance
procedures are undertaken.
CLEANING THE LOG SET AND FIREBOX
During the annual inspection and maintenance appointment,
the service person
should clean
dust, lint and any light soot accumulation from the logs and the fire box area. An extra soft brush
should be used on the logs, as they are extremely fragile. If at any time the logs cannot be
removed or installed without force, the cause must be found. The logs must never be forced.
Procedure:
1. Remove Front Door as described on page 11.
2. Remove the complete log set from the firebox by lifting it up and out. Brush it gently over a
newspaper and carefully place it out of the way.
3. The bark tray can be removed by lifting its feet over the bottom gasket retainer and pulling it
straight out, with the bark still on it.
4. The bark consists of a mixture of vermiculite and composite chips and it can be dusted by
sieving. If needed a replacement bag can be ordered through your YUNCA dealer. (See parts
list for reference number)
5. With firebox empty, a vacuum cleaner can be used to remove any visible dust and lint from
within the firebox area.
6. Replace the bark tray.
7. Replace log set and redistribute bark.
8. Replace and relatch the front door and close the side panels.
INSPECTING THE VENTING
An inspection of the venting system should be made during the annual service appointment.
There must be no blockages and the flue must be in good repair. Any sections that are taken
apart for inspection must be reassembled and sealed as required.
FIG 5:
GAS CONTROL VALVE CONNECTIONS
