Revised 04-08-10
YUNCA Leedz FS Fuzzy Feb 2010
Page 11 of 19
MANUAL CONTROL PANEL OPERATION
MAINTENANCE
A qualified service person should conduct an annual inspection and undertake any maintenance
required on your
LEEDZ
(Fuzzy Logic control). Its’ venting and installation must be checked to
keep it running safely and efficiently.
REMOVING THE FRONT DOOR
Note:
The door can only be removed after the heater has been turned off for long enough so
that the door has cooled to touching temperature.
1. First the side panels must be removed, to do this grip panel at its base and pull out. The panel
should be swung out to about 30 degrees and then pulled down to release the locating pins in
its top.
2. This will expose the restraining latches at each side. To open these latches lift the butterfly
grip forward and twist it through 180 degrees. Ensure that the latch hook is clear of the door
frame.
3. The front door can now be removed by griping it by its back bottom corners and pulling it
straight back and out towards you.
Note: It is important not to spread the sides out any further than is necessary to remove door,
as this may damage the enamel coating on the door.
REMOVING THE GLASS FOR REPLACEMENT
1. Remove the front door as described above, and place front down on a soft surface.
2. Remove the two side glass retainers by taking out the three bolts in each one.
3. Remove the bottom front glass retainer by taking out the four screws along the base of the
door.
4. To remove the front glass place one hand under it and lift it up and out of the doorframe.
5. Remove the side glasses
6. New glass (1610LFF, 1610LFS) and thermotape seal (1611LFF, 1611LFS) can be ordered
through your YUNCA agent.
Note: Only recommended heat resistant glass may be fitted.
7. Place replacement glass in position in the reverse order of removal, i.e. Side glass should be
placed in position before front glass.
8. Replace side and bottom glass retainers with their respective bolts and screws.
Note: Tighten the screws and bolts alternately, do not over tighten to avoid damaging glass.
Should the remote control be mislaid or damaged, your fire
can be operated using the
control panel on the front of the
fire
, (Fig 4) located on the front panel.
Press and hold the
POWER
button to light the fire (starts on
high).
Press again to reduce to medium, and again to reduce to
low.
A further press of the power button will turn the fire off.
The
PWR
light will flash if battery is low.
The
AUTO
light will flash (when the fire is off) as a reminder that the timer has been activated.
IR receiver Power
Auto setting on Power on &
(indicator)
Battery low
(indicator)
FIG 4
