Revised 26/05/10
ALLURE ELECTRONIC Install Ops May2010
Page 12 of 23
1
2
3
4
7
3
5
6
3
3
7
REMOVING PANELS
)
GRATE
Lift up and out.
2) HEARTH
Lift up and out.
3) FASCIA FRONT
Remove four side screws, two are just in from the
sides at the top, and two at the bottom. Lift the fascia
up slightly and pull forward.
3a) BOTTOM FASCIA STRIP
(Not shown) This part may be fitted along the base of
a regular three-sided fascia (shown above) to give a
“picture frame” effect. When the fascia front is
removed you will see where the bottom strip is fitted
using two screws.
4) TOP LOUVRE #1 (Top)
Slides out for easier access to the top front cowl and
flue spigot – refer 7. May be left in place if access to the
flue spigot is not required.
5) TOP LOUVRE #2 (Bottom)
Remove two screws and slide off. May be left in place if
work is not being carried out on the top cowl or flue
spigot.
6) BOTTOM CONTROL AND GRILL
Remove two screws from the long tabs and tilt forward
slightly to pull out over the control knob. The control
knob can be removed (pull) if necessary.
7) COWL TOP FRONT
Removing the cowl top front gives access to the flue
spigot (visible when fascia is removed).
Remove two screws and slide out.
