8
Yukon
®
Fitness
Equipment
Rev. C
CLM-150
Issued 12/08/2004
1. Thigh support assembly (step 7)
2. Seat support
Step 8.
• Insert the thigh support (1) assembled in step 7
into the seat support (2).
1. Ball end of Upper cable
2. Pulley
3. 3/8” x 2 1/8” Hex bolt
4. 3/8” Washer
5. 3/8” Nylon nut
6. Boom
7. Upright
8. 3/8” x 3 3/8” hex bolt
9. Pulley plate
10. Bolt end of Upper cable
11. 1/2” Nut
12. 1/2” Washer
13. Top plate
Step 9. (Upper Cable)
•
In the illustration, the order that the pulleys
get installed are labeled “a” through “d”.
• Put the bolt end (10) of upper cable through
the long slot at top of upright (7) and then secure
it to the shaft selector/top plate (13) with a 1/2”
washer (12) and nut (11).
Note:
The ball end of the cable should remain
at the front.
• Next, attach a pulley (2a) to the front of the
boom (6) using a 3/8” x 2 1/8" bolt (3), two
washers (4), and a nut (5).
Make sure cable
runs over the top of the pulley.
• Continue by running upper cable over the top of
another pulley (2b). This pulley is attached to the
upright (7) with a 3/8” x 3 3/8” bolt (8), two
washers (4), and a nut (5).
• Run cable over another pulley (2c) and attach
this pulley to back of boom (6) using a 3/8” x
2 1/8” bolt (3), two washers (4), and a nut (5).
• Between the two pulleys at "b" and "c" attach
a pulley (2d) to the top hole of two pulley plates
(9). Use a 3/8” x 2 1/8” bolt (3), two washers (4),
and a nut (5).
The cable should run under pulley.
Assembly instructions (Contd)
1
2
3
4
4
5
6
8
9
10
11
12
3
7
3
4
13
a
b
c
d
1
2