9
Yukon
®
Fitness
Equipment
Rev. C
CLM-150
Issued 12/08/2004
Step 11.
• Attach each foot plate (1) to the front base (3)
with a pull pin (2).
1. Foot plate
2. Pull pin
3. Front base
1. Ball end of Low row cable
2. Front base
3. 3/8” x 2 1/8” Hex bolt
4. 3/8” Washer
5. Pulley
6. 3/8” nylon nut
7. Low row cable
8. Seat support
9. Upright
10. 3/8” x 3 3/8” Hex bolt
11. Tab of Front base
12. Snap link
13. Eye hole end of Low row cable
14. Pulley plate
Step 10. (Low Row Cable)
•
In the illustration, the order that the pulleys
get installed are labeled “a” through “c”.
• Put the “eye hole” end (13) of low row cable
through the slots of the seat support (8) and
upright (9).
Note:
The ball end of the cable should remain
at the front.
• Attach a pulley (5a) to the front of the front base
(2) using a 3/8” x 2 1/8" bolt (3), two washers (4),
and a nut (6).
Make sure cable runs under pulley.
• Install another pulley (5b) to bottom of upright (9)
with a 3/8” x 3 3/8” bolt (10), two washers (4),
and a nut (6).
Make sure cable runs under this
pulley also.
• Loop cable over another pulley (5c) and attach
this pulley to the bottom holes of the pulley plates
(14) using a 3/8” x 2 1/8” bolt (3), two washers (4),
and a nut (6).
• Finish lower cable installation by attaching the
“eye hole” end (13) to the small tab (11) of the front
base using a snap link (12).
•
WARNING:
Always stand on foot plates when
performing any type of standing
exercise with the low row cable
(example: bicep curls, upright rows,
shrugs, etc…). Failure to do so may
result in the tipping or lifting of machine.
Assembly instructions (Contd)
13
14
3
5
12
1
2
3
4
5
6
7
8
9
10
11
4
a
b
c
1
2
3