Yudo ACT-D800, Инструкция по эксплуатации

Страница: 12 / 15

In case that there is a wide difference in area due to a
complicated molding product. Apply mode A for gate
A~D and Mode B for gate E.
Using this sequence will enable the gate feeding the
very small area to be closed before the injection ends.
如图所示，由于产品成形的复杂性，每个浇口所成形的区域
面积有很大的差异。运用模式
A
控制浇口
A~D
，模式
B
控制
浇口
E
。使用时间控制器能确保浇口在注射结束关闭时，填
充满其最小区域。
10
、
System Applications
◆
Application for Mode A
①
In case that short molding occurs at the extreme of
the product.
Open the gate A to fill the major portion of the molded
part, and then open the gate B to fill the short molded
area of the component.
①如图所示，胶未填充的地方往往发生在产品的极端部位。
首先浇口
A
填充好成形的大部分，然后浇口
B
填充胶未注射到
的部位。
◆
Application for Mode B
②
In case that there is a wide difference in the molding
area of the component.
Firstly, open the gate A where the molding area is large
in order to fill this section precisely, and then open the
gate B to fill the small area.
Adjusting flow balance by the gate open time will
ensure that the component is filled evenly.
②如图所示，在产品的成形区域有很大的差别。位于较大区域
的浇口
A
首先打开，目的是为了精确的注满这部分，然后，浇
口
B
打开填充其较小注射区域。通过控制浇口的开放时间，调
节流道的平衡，以确保产品能被均匀的注射满。
Gate A Gate B
Gate A Gate B
Gate A Gate B
Gate D Gate C
Gate E
9
Shot Short