YTL 23316, Инструкции и сборка, Страница: 18 / 24

- 18 -
WARNING
Before troubleshooting or attempting to service, read the and follow all safety instructions to avoid
serious injury to the operator or bystanders from moving parts that can crush or cut, burns, fire or
explosion, or escaping high pressure hydraulic fluid.
Problem
Cylinder rod will not move Solution: A, D, E, H, J
Slow cylinder shaft speed when extending or
retracting Solution: A, B, C, H, I, K, L
Wood will not split or splits extremely slowly Solution: A, B, C, F, I, K
Engine bogs down during splitting Solution: G
Engine stalls under low load condition Solution: D, E
Cause Solution
A- Insufficient oil to pump Check oil level in reservoir
B- Air in oil Check oil level in reservoir
C- Excessive pump inlet vacuum Check pump inlet hose for blockage or
kinks
D- Blocked hydraulic lines Flush and clean the splitter hydraulic
system
E- Blocked control valve Flush and clean the splitter hydraulic
system
F- Low control valve setting Adjust control valve with a pressure gauge
G- High control valve setting Adjust control valve with a pressure gauge
H- Damaged control valve Return control valve for authorized repair
I- Internal control valve leak Return control valve for authorized repair
J- Damaged cylinder piston Return cylinder for authorized repair
K- Internally damaged cylinder Return cylinder for authorized repair
L- Drawing air through suction line Check and tighten hose clamps on suction
hose
Troubleshooting