You-Q XP, Руководство по обслуживанию, Страница: 28 / 54

5.7.2. RepIace the tilt actuator 25 degrees
Preparation
1. Set the seat in the maximum tilted position for easy access.
2. See section 5.1.
Procedure
1. Make sure that the seat is kept in the tilted
position. For instance by placing a support.
2. Remove the seat cushion for easy access.
3. Disconnect the actuator cable.
4. Remove the circlips (A) from the pivots B at
both ends of the actuator (F).
5.
WARNING!
Make sure that the tilted
seat is supported safely.
Remove the old actuator.
6. Put the new actuator into the tilt
mechanism.
7. Connect the actuator cable.
8. Make sure that the actuator cable can follow
the movement of the mechanism but that
the cable does not get jammed by the
mechanism.
9. Check the functionality of the actuator.
D
A
A
B
F
C
A
E
A
B
C
5.8. Seating system EQLASS
5.8.1. Replace the actuator of the backrest
Preparation
See section 5.1.
Procedure
1. Remove the seat cushion for easy access.
2. Disconnect the actuator cable from the
actuator.
3.
WARNING!
Make sure that the
backrest is in a horizontal
position and that is
supported in this position.
Remove the mounting clip (B).
4. Remove the screw, washer and nut (C).
5. Remove the old actuator (A).
6. Remove screw, washers and nut (D).
7. Remove the mounting fork (E) from the
actuator. The mounting fork is re-used with
the new actuator.
8. Put the mounting fork on the new actuator.
9. Put the new actuator into the seating
mechanism.
B E
C
A
D
Maintenance tasks & adjustments
28 Service manual - XP