4-27
IM 04L51B01-41EN
Using the Maintenance Console
1
2
3
4
5
10
App
4.6
Configuring Router Modules
This section explains the configuration of router modules when routers are installed in fixed
locations. When using routers as low-speed moving bodies, see section 4.8, “Configuring
Router Modules (low-speed moving bodies).”
4.6.1
Setup Procedure
Configure router modules by following the procedure below.
…
A step that needs to be performed
Step name
…
A step that is performed when the condition written on the
right side applies
Step name
…
See “Router Configuration Selection Window,” “Router Configuration
Window,” “Connecting to a Wireless Communication Router Module”
…
Set terminal information of the wireless communication module.
See “Basic Configuration Tab”
…
Configure serial communication.
See “Communication Setup Tab”
…
Configure packet filtering.
See “Packet filtering tab”
…
Set a fixed route.
See “Fixed Route Setup Tab”
…
When saving the configuration file
See “Saving the configuration file (Save Configuration button)”
…
Set the network scale.
See “Network Scale Setup Tab”
Connect the router module.
On the Basic configuration tab, enter the
terminal information of the wireless
communication module
On the Fixed route setup tab, enter the
fixed route settings.
Save the configuration file.
Restart the wireless device.
End configuration
On the Communication setup tab, enter
the serial interface information between
the wireless communication module and
connected devices.
On the Packet filtering tab, enter the
protocol information used between the
wireless communication module and
connected devices.
Optimize the control signal transmission
frequency of the wireless communication
module according to the network scale.
Main window
