P1
DS1054-057
Access the RADIO RF menu to check the correct operation of the wireless connection. Use the two buttons
and
to navigate through the menu until it appears on the display:
Press
to start the test.
The message “RF test” will flash and symbol
(if the thermostat is set to heating mode) or
(if the thermostat
is set to cooling mode) will switch every 3 seconds between the
present and absent conditions. The relay of the connected MTR (or MTRs) will switch accordingly from closed
with symbol
or
on the display, or otherwise open.
Press the button
again to stop the test or
to return directly to the beginning of the radio-frequency
menu.
IMPORTANT:
There is no timeout to release the thermostat from RF Test condition.
Note:
When configured in this way, the thermostat cannot be accessed remotely or locally via the Yno app. In
order to do so, it must be installed in a Yokis system equipped with hub and configured using the YokisPRO
app instead of its own menus. See below.
10.4.4. YOKIS PRO: Single-zone thermostat configuration with direct wiring
The thermostat is considered as a Control Point in the AppPRO.
To configure it, it must therefore be added, like any other control point (e.g. remote controls), to the room where
it will be installed.
After you have given it a name (e.g. “Thermostat”), configure the various parameters, which appear at the
bottom of the screen.
Содержание Thermarp
Страница 38: ...DS1054 057 P38...
Страница 39: ...P39 DS1054 057...
