YILMAZ REDÜKTÖR E Series, Руководство по эксплуатации

Страница: 46 / 52

ID Problem Observation Remedy
025
Motor is running but
Gearbox shaft does
not turn
Scratching noise comes out
Some part (key, gear) may be defect inside gearbox. Got o ID
100.
026 Gearbox Housing is
Defect You are using chain drive or
pinion gear
The radial load or poligon effect of the chain may have caused
the damage. Check also if the assembly bolts are loosened or
the plate you assemble the gearbox is rigit enough. Check if you
are using the correct diameter of chain drive and you are not
exceeding max. allowed radial load. Check the position of your
output element and re-calculate your radyal load and check if this
fit to the maximum allowed radial load. Go to ID 100.
027 Output Shaft is Defect
You are using chain drive or
pinion gear
The radial load or poligon effect of the chain may have caused
the damage. Check also if the assembly bolts are loosened or
the plate you assemble the gearbox is rigit enough. Check if you
are using the correct diameter of chain drive and you are not
exceeding max. allowed radial load. Check the position of your
output element and re-calculate your radyal load and check if this
fit to the maximum allowed radial load. Go to ID 100.
028
Gearbox is stopping
too late
You are using braked motor
Please check the wiring diagram of the brake. There are two
different kind of brake wiring diagram. The standart gearbox de-
livered from our factory is set to delayed braking. For sudden
braking check the wiring diagram.
029
Gearbox is starting too
late
You are using braked motor
A 24V shock transformer is recommended for fast opening of
big brakes (
≥ 200 Nm) and shock rectifier is recommended for
smaller brakes (< 200 Nm). Go to ID 100.
100 Service Required No self solution found
Please contact YILMAZ REDUKTOR Service point. See on the
back side of this manual. Changing mechanical parts of gearbox
can only be done by YILMAZ REDUKTOR or with information
of YILMAZ REDUKTOR. Any change without informing YILMAZ
REDUKTOR will cancel the waranty, manufacturer decleration
and YILMAZ REDUKTOR will take no responsibility.
11- Disposal
If your product is no longer of use and you wish to dispose of it, refer to the instructions here. If you
have any questions regarding ecological disposal methods, please consult our service points given on
the backside of this manuel.
11.1- Disposal of Oil
Lubricants (oil and greases) are hazardous substances, which can contaminate soil and water.
Collect drained lubricant into suitable receptacles and dispose of it according to the valid national guid-
lines.
11.2 - Disposal of Sealings
Remove the sealing rings from the gear reducer, and clean them of oil and grease resudies.
Dispose of the sealings as composite material (metal/plastic)
11.3- Disposal of Metal
Divide up the remainder of the gear reducer into iron, aluminium, non-ferrous havy metal if possible
Dispose of it according to the valid national guidelines.
Troubleshooting Guide
46
Operating Instructions
E Series