2.4 Safety instructions
1. Before installation or operation of equipment read all safety instructions warnings and
operating instructions.
2. Heed all warnings on the equipment.
3. Follow the operating instructions.
4. The equipment may only be used for the purpose described in the operation instructions.
5. Keep operating instructions for future reference.
6. Never use the equipment in the immediate vicinity of water. Ensure that water or damp cannot
get into the equipment.
7. Only install or fit the equipment in accordance with the manufacturers recommendations.
8. Ensure adequate ventilation when installing.
9. Never install or fit the equipment in the immediate vicinity of sources of heat such as boilers,
heating units and other equipment which generates heat. (Including amplifiers and other
electronic equipment.)
10. When connecting to a power supply ensure that it is the correct voltage and only use cables
as specified by the manufacturer in the operating instructions, or, as shown on the connector
panel of the equipment.
11. Only connect the equipment to a legally approved, earthed, mains power supply.
12. Position the power cable or cord in such a way that it cannot be walked upon or come into
contact with any object or thing that could damage the cable or cord. Attention should be given
to the point where the cable is attached to the equipment, and, where the cable connects to
the approved supply.
13. Ensure that foreign objects and liquids cannot get into the equipment.
14. Only clean the equipment as recommended by the manufacturer.
15. Disconnect the power cable or cord from the power supply if the equipment will be out of use
for a prolonged period.
16. In any situation where an incident occurs which could render the equipment unsafe, for
example
· damage to the power cable or cord
· entry of foreign objects or liquids (including water) into the equipment
· the equipment has been dropped or the casing has been damaged in any way
· any apparent change in performance
have the equipment checked immediately by a person technically qualified to make such
checks.
17. Never carry out any work on the equipment other than as specified in the operating manual.
VIP
digital
Manual 4.0 Yellowtec 2004 Rev. 26.07.2004
Page 9
