yellow jacket BJ-830008, Руководство пользователя

Страница: 6 / 16

6
Clip
ASSEMBLY
1. Familiarize yourself with the jack.
Lifting Arm
Saddle
Front Wheel
Rear Swivel Casters Pump Plungers
2. Prior to assembly, carefully remove the retaining
clip attached to the handle socket.
CAUTION: The socket will tend to spring upward
when the clip is removed. To prevent possible
injury, place one hand on the top of handle socket
to control the upward motion of the handle socket
retaining clip, and then carefully remove the retaining
clip. After removed slowly allow handle socket to rise
back into resting position.
Once retaining clip is removed,
SLOWLY allow handle socket to rise
back into resting position. Use
CAUTION when removing retaining
clip, handle socket will spring forward
rapidly.
WARNING!
4. Unfasten the screw located in the Handle Socket
to insert the assembled handle.
5. Line up the square hole located at the bottom of
the handle over the square bolt inside the Handle
Socket.
6. Secure the handle in place by tightening the
screw in the Handle Socket Without any vehicle
on the jack. Cycle the lift up and down several
times to insure the hydraulic system is operating
properly. (Perform to the Air Purge Procedure
before first use.)
Handle
Pc. 2
Handle
Pc. 1
Quick
Disconnect
Handle Socket
Screw
WARNING: Do not lift or carry jack by handle.
Handle could dislodge and jack may fall,
resulting in possible injury or property damage.
3. Refer to handle image when performing this
step. Press Quick Disconnect on handle piece
2, this will allow slide handle pieces 1 and 2
connect, align the holes on both sections to allow
quick disconnect to trigger. Quick disconnect
will automatically pop out when hole position is
correct.