YATO YT-30436, Руководство пользователя

Страница: 14 / 88

ORIGINAL INSTRUCTIONS
14
EN
Do not disassemble the product and the laser module. Do not modify or retro fi t the device on one’s
own. Do not drill any holes in the device’s housing.
Do not operate the product in an explosive atmosphere or near fi re sources.
Do not immerse the product in water or any other liquid. Relative humidity at the workplace should not
exceed 85% without condensation.
Do not expose the product to shocks or impacts. Do not store this product with other tools. Transport
the product when it is turned o ff with the locked laser pointer.
Do not expose the product to high temperatures – for example, in a closed car interior.
For powering the device use only the battery supplied with the product. It is not allowed to use other
batteries. It is not allowed to modify the battery socket in order to match the battery to the device.
Charge the battery only with the cable and charger supplied with the device.
Disconnect the battery from the device when storing the laser.
Do not expose the product to shocks or impacts. Do not store this product with other tools. Transport
the product when it is turned o ff with the locked laser pointer.
PRODUCT OPERATION
Charging the battery
Charge the battery before use. The battery can only be charged when it is installed in the tool. To
install the battery pull the battery compartment lid latch and open the lid (II). Insert the battery into
the socket.
Connect the plug to the socket of the battery or to the socket of the device if the battery is installed in
it (III). During landing, the charging indicator light fl ashes green and turns solid when fi nished.
After fi nishing charging, immediately disconnect the charger from the power supply and then the
cable from the battery. Secure the battery charging socket with a cap.
The lithium-ion battery (Li-Ion) has a reduced memory e ff ect and can be charged at any time, but it is
recommended to fully discharge the battery during normal operation and then fully charge it once for
several charging processes. This will extend the battery service life. Do not short-circuit the battery
contacts in order to discharge it or for any other reason – it may cause fi re or explosion. To check
the charge status of the battery, use the indicator – the more status lamps are illuminated, the higher
the battery charge level. Leaving a fully charged battery connected to the charger can signi fi cantly
shorten its service life.