ORIGINAL INSTRUCTIONS
15
EN
Turning the device on and o
ff
(IV)
Pressing the switch starts the device regardless of the lock position. If the lock is moved in the direc-
tion of the padlock symbol, the device will start in a manual mode. If the lock is moved to the open
padlock symbol, the device will start in the laser pointer self-levelling mode.
The device is switched o
ff
in manual mode by pressing and holding the switch for approx. 2 seconds.
The device operating in the laser pointer self-levelling mode will be switched o
ff
after moving the lock
towards the padlock symbol.
During storage, it is recommended to move the laser lock as far as possible towards the closed
padlock symbol. This will immobilise the laser module inside the device housing, reducing the risk of
damage to the product during transport and storage.
If the device is running, successive presses of the switch allow you to change the laser beams. The
default setting is to display one horizontal omnidirectional and two vertical omnidirectional beams.
Successive presses of the switch trigger the following output: one horizontal omnidirectional laser
beam; one vertical omnidirectional laser beam; one horizontal omnidirectional laser and one vertical
omnidirectional laser beam; two vertical omnidirectional laser beams.
Automatic laser pointer levelling
Caution! The automatic laser pointer levelling function can only be used if the tripod thread points
downwards. Any other position of the product will be signalled as exceeding the automatic adjustment
range.
Setting the lock on the open padlock symbol will activate the automatic laser pointer levelling mech-
anism. If the product is tilted at an angle within the automatic adjustment range, the projected lines
will be automatically levelled.
If the displayed lines pulsate (approx. 3 times per second), it means that the product is tilted by an an-
gle greater than the adjustment range in which case automatic levelling will not be possible. Change
the position so that the displayed lines stop pulsating.
Manual mode
The manual mode is useful when the device must be tilted. In manual mode, the laser beam is emitted
with the automatic adjustment mechanism locked, the lock must be moved as far as possible towards
the closed padlock symbol.
Then press and hold the power switch. The laser lines will be displayed. To turn o
ff
the device operat-
Содержание YT-30436
