Yardworks CLM48CU, Инструкция по эксплуатации

Страница: 26 / 36

model no. 060-1980-6 | contact us: 1.866.523.5218
26
Troubleshooting
Problem Solution
Mower doesn’t run when
switch lever is activated
Release switch lever to turn mower off. Remove the battery pack. Turn
mower over and check that blade is free to turn. If not free, contact
Yardworks
®
at 1.866.523.5218. Blade should turn freely.
Has battery been fully charged? If not, recharge the battery pack.
Motor stops while mowing
Turn mower off. Remove the battery pack. Check that blade is free to
turn. If not free, contact Yardworks ® at 1.866.523.5218. Blade should
turn freely.
Raise cutting height of wheels to highest position and start mower.
Has battery been fully charged? If not, charging the battery pack.
Avoid overloading the mower. Slow down the cutting pace by pushing
mower slower or raising the cut height, or both.
Mower runs but
cutting performance is
unsatisfactory, or does not
cut entire lawn
Has battery been fully charged? If not, recharge the battery pack.
Turn mower over. Remove the battery pack. And check blade for
sharpness. Keep blade sharp. Check deck and discharge chute for
clogging.
Wheel height adjustment may be set too low for grass condition. Raise
cutting height.
Mower is too hard to push
Raise cutting height to reduce deck drag on grass. Check each wheel
for free rotation.
Mower is abnormally noisy
and vibrates
Turn mower off. Remove the battery pack. Turn mower on side and
check blade to ensure it has not been bent or damaged. If blade is
damaged, replace with a replacement blade. If the underside of the
deck is damaged contact Yardworks
®
at 1.866.523.5218.
If there is no visible damage to the blade and the mower still vibrates:
turn mower off, remove the battery pack, and then remove blade.
Rotate blade 180 degrees and retighten. If mower still vibrates,
contact Yardworks at 1.866.523.5218.
Mower not picking up
clippings with the grass
collection bag
Remove mulch insert when bagging.
Chute clogged. Release switch lever to turn mower off. Clear chute of
grass clippings.
Too much cut grass. Raise cutting height of wheels to shorten length
of the cut.
Bag full. Empty bag more often.
When mulching there are
clippings visible
Too much cut grass. Raise cutting height of wheels to shorten length
of the cut. Do not cut off more than 1/3 of total length.
Check blade for sharpness. Always keep blade sharp.
Low or diminished run-time
after many uses
Contact Yardworks
®
at 1.866.523.5218.