Yanmar ViO80-1A, Руководство пользователя по эксплуатации и обслуживанию

Страница: 108 / 215

5 C
HECKS AFTER START
-
UP
WARNING
Emergency stop : if an abnormal action occurs, turn the key in the ignition switch to the
OFF position. The electrical system is interrupted and the engine stops. Ask your dealer to
check the machine.
IMPORTANT
The hydraulic oil must be at a temperature from 50°C to 80°C. If the temperature is low,
wait until it reaches 20°C before using the equipment. If you need to use a command lever
before the oil reaches this temperature, handle it gently.
Do not accelerate suddenly if the engine is not hot.
After the engine starts, do not use the machine immediately but respect the following
procedure :
1. Run the engine on idle and check that the engine oil pressure alarm light is off.
2. Check that the gauges and the screen correspond to the following statuses :
1= Diesel gauge normal
2= Cooling fluid temperature indicator normal
3= Time counter normal
4= Engine oil pressure alert indicator off
5= Battery charge warning alert off
6= Water temperature alarm light off
7= Warning light & Alert light off
3. Set the engine speed switch setting between idle and full throttle positions. Run the engine
about 5 minutes with no load at the intermediate rotational speed.
4. Unlock the locking levers and lift the bucket from the ground.
5. Use the joysticks to extend and retract the bucket and arm cylinders to the end of their run.
Alternately run the bucket cylinder for 30 seconds then the arm cylinder for 30 seconds over
a total duration of around 5 minutes to raise the hydraulic oil temperature to at least 20°C.
IMPORTANT
When moving the accessory, make sure it does not hit the ground or the machine.
IMPORTANT
Check that there is no abnormal noise in the hydraulic circuit.
91