YANGTECH EMP Series, Руководство по эксплуатации

Страница: 5 / 23

A05G069A
5
3. INSTALLATION
⚫
This product is suitable for universal power source(100V~240V AC/φ1/ 25Watts
RMS), but installer still need to confirm that the power source is in the range.
⚫
Make sure this pump is horizontally installed.
⚫
Pump base dimensions illustrate below
：
1. 4 long-shape holes for M5-25 fixing
screw
2. 2 oblique-shape holes for M4
、
M5
、
M6 fixing screw
3. Standard accessories
：
SUS304
M5-25 Socket head cap screw
*2+M5 nut*2+M5 plate washer*4
⚫
This pump equip with 2 meters length 5-cores cable (standard) and 13-cores
cable(multifunctional model only). Use a junction box(optional) connect them to
external power source/level sensor/signal/switches.
⚫
Install this pump in a place of ventilation(environment temp, between 0~40℃). Keep
away from high temperature / high humidity / corrosive gases.
⚫
If operate pump continuously at high pulse rate and long period of time, the
temperature of case may reach 60
℃
. If you touch with bare hand you feel very hot
but this is normal. Yet if operation condition cause over-temperature-protect-switch
(inside the pump) acts frequently. You should check power source/liquid
viscosity/environment temperature/ ventilation etc. to solve this problem.
⚫
Fasten the pump on a horizontal and rigid base. This prevent pump from loosing or
falling and ensure safety of operator.
⚫
After install the pump, connect to pump both inlet/outlet and check valve with
standard hoses. (1/4” PVC hose
，
I.D.
φ
6.0mm
，
O.D.
φ
11mm) Keep a distance of
about 25~30cm between check valve and tank bottom to prevent from suction of
precipitations.
⚫
The inlet/outlet connectors are made of plastic, use bare hand to rotate and fasten
them. Do not try to fasten connectors with tools it may break the connectors.
⚫
If pump into a pressured pipe/tank, a injector ( an optional accessory ) is needed .