YANGTECH EMP Series, Руководство по эксплуатации

Страница: 13 / 23

A05G069A
13
⚫
CODE DESCRIPTIONS
：
CODE CODE NAME UNIT DESCRIPTIONS
01
Lowest Stroke
Rate
p/m
Default=0
，
Variation=0-80
(In Mode 4,5,6 is invalid)
02
Lowest Stroke
Rate
p/m
Default=200
，
Variation=100-200
(In Mode 4,5,6 is invalid)
03
Dividing -
Default=01
，
Variation=1-9999
04
Multiple -
Default=01
，
Variation=1-9999
05
Batch Timer sec
Default=9999
，
Variation=0-9999
1. Actually count-down timer = (cd05) * (cd07).
For example, if cd05=5000 and cd07=100
then count-down
timer=5000*100=500000(seconds)
2. If value excesses 4 digits, 1~3 decimal points
will blink to hint how many digits wasn`t
shown up.
06
Batch Pulses
Counts
Pulse
Default=9999
，
Variation=0-9999
1. This code is similar to code05. Actually
count-down pulses= (cd06) * (cd07). For
example, if cd06=5000 and cd07=100 then
count-down
pulses=5000*100=500000(pulses)
2. If value excess 4 digit, 1~3 decimal points
will blink to hint how many digits wasn`t
shown up.
07
Code5,6,9,A
multiple
-
Default=1
，
Variation=1
，
10
，
100
，
1000
Valid in mode7,8,9
08
Flow Rate
At 200 Hz.
ml/min
Default=100
，
Variation=1-9999
Calibration procedure
：
1. After installed pump and check all pumping
conditions are ready.
2. Switch to mode1 and set pump rate up to 200
pulse/min.
3. Use stopwatch and graduated cylinder to
measure the volume of pumping for 1 minute.
4. Input the result to code08. This makes LED
unit display in ml/min accurately.
09
Mode9 Running
Time
sec
Default=60
，
Variation=1-9999
Set pump running period of mode9.
0A
Mode9 stopping
Time
sec
Default=60
，
Variation=1-9999
Set pump stopping period of mode9.