Yamato G800-2T, Инструкция по эксплуатации

Страница: 22 / 36

Cod. 94716
22
Engine will not start 2. ignition switch in ‘’off’’
position
2. turn to ‘’on’’ position
3. faulty spark plug 3. replace spark plug
4. choke in wrong position 4. adjust choke accordingly
5. unit loaded during start-up 5. remove load from unit
6. spark plug wire loose 6. Attach wire to spark plug.
7. unit may be flooded 7. Leave the generator rest
for 5-10 minutes and then
try again, following the
instructions when doing so.
Alternatively if the choke
lever is in full choke position
(start), switch the choke to
the run position and try to
re-start.
8. old fuel 8. remove the existing fuel
and replace with new
AC power supply-
No electrical output
1. faulty receptacle 1. have service centre
replace receptacle
2 .faulty power cord 4. Replace cord.
DC power supply-no
electrical output
1. circuit breaker kicked out
(DC only)
1. Yes-Depress the reset
button, to rest the circuit
breaker.
Repeated circuit
breaker tripping
1. overload 1. reduce load
2. faulty cords or equipment 2. Check for damaged,
bare, or frayed wires on
equipment. Replace.
3. Incorrect cables used. 3. Check to make sure you
are using the DC Cables
could result in the crossing
over of polarity,
4. mixed polarity 4. Check to make sure that
the DC cables are
connected to the correct
battery polarity terminals.
That is po) to positive
（
+
）
and negative(-) to
negative(-).
Generator
overheating
1. generator overloaded 1, reduce load
2. insufficient ventilation 2. Move to adequate
supply of fresh air.
Generator stops
1. generator may have fallen
over
1. Check to make sure that
the generator is in it is
correct upright position. If
not take corrective action
to put it in the upright
position.
2. Generator may have ran out
of fuel.
3. Check to make sure that
the generator has fuel in it.
If not take corrective action
to top up the fuel tank,
3. Generator may not be
correctly ventilated with free
flowing air.
4. Check and make sure
that the generator is
located in an appropriately
ventilated environment, if
not relocate the generator
to a well ventilated
location.