9
En
PLACING THIS SYSTEM
PREPARATI
O
N
Engli
s
h
■
Attaching the center system to a wall
Installing the center system using the keyholes
You can attach the center system to a wall using commercially available screws (#8, Diameter: 7.5 mm or more
(5/16” or more)).
1
Attach the supplied mounting template on a
wall and mark the holes of the mounting
template.
2
Remove the mounting template and then
install the commercially available screws at
the marks.
y
To install the cables above the center system, refer to the right
column.
3
Hang the center system on the screws using
the keyholes on the back of the center
system.
When installing the center system on a wall, all installation work must be performed by a qualified
contractor or dealer. The customer must never attempt to perform this installation work. Improper or
inadequate installation could cause the center system to fall, resulting in personal injury.
Tapes or thumbtacks
Mark
4 to 6 mm (3/16” to 1/4”)
Diameter:
7.5 mm or more
(#8, 5/16” or more)
Installing the cables above the center system
To pass the cables upward, you need to attach the
spacers to make room on the back of the center system.
In step 2 of the left column;
2-a
: Attach the supplied spacers to the rear panel of the
center system using the supplied double-sided
tapes. You can choose either the side A or the side
B.
2-b
: Remove the mounting template and then install
the commercially available screws at the marks.
A: For narrow space
B: For wide space
Double-sided
tape
Double-sided
tape
Attach
Attach
22 to 24 mm
(7/8” to 15/16”)
34 to 36 mm
(1-5/16” to 1-7/16”)
