Yamaha TT250RX 2007, Руководство пользователя

Страница: 48 / 86

PERIODIC MAINTENANCE AND MINOR REPAIR
6-11
1
2
3
4
5
6
7
8
9
NOTE:
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
CAUTION:
ECA11620
● In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of “CD” or oils of a high-
er quality than specified. In
addition, do not use oils labeled
“ENERGY CONSERVING II” or
higher.
● Make sure that no foreign mate-
rial enters the crankcase.
13. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
14. Turn the engine off, and then
check the oil level and correct it if
necessary.
CAUTION:
ECA10970
After replacing the engine oil, make
sure to check the oil pressure as de-
scribed below.
●
Remove the bleed bolt from the
engine oil filter element cover.
●
Start the engine and keep it
idling until oil flows out. If no oil
comes out after one minute,
turn the engine off immediately
so it will not seize. If this occurs,
have a Yamaha dealer repair the
vehicle.
● After checking the oil pressure,
tighten the bleed bolt to the
specified torque.
Recommended oil:
See page 8-1.
Oil quantity:
Without oil filter element replace-
ment:
1.10 L (1.16 US qt) (0.97 Imp.qt)
With oil filter element replacement:
1.20 L (1.27 US qt) (1.06 Imp.qt)
1. “CD” specification
2. “ENERGY CONSERVING II”
1
2
1. Bleed bolt
Tightening torque:
Bleed bolt:
7 Nm (0.7 m·kgf, 5.0 ft·lbf)
1
ProCarManuals.com