Yamaha TT-R90(S), Руководство по эксплуатации для владельца

Страница: 160 / 364

3 - 17
INSP
ADJ
●
Check the steering shaft by turning it lock
to lock. If there is any binding, remove the
steering shaft assembly and inspect the
steering bearings.
●
Install the handle crown 6 , handlebar 7 ,
and front fender.
CAUTION:
Install the handlebar holder with its
groove
a
facing outward, and tighten
the bolts so that the gaps
b
are equal.
T
R
.
.
Steering stem bolt:
40 Nm (4.0 m • kg, 2.9 ft • lb)
Front fork cap bolt:
40 Nm (4.0 m • kg, 2.9 ft • lb)
Handlebar upper holder:
13 Nm (1.3 m • kg, 9.4 ft • lb)
a
b
b
TT-R90E
●
Steering ring nut
Steering ring nut adjustment steps:
●
Remove the front fender 1 .
●
Remove the handlebar and handle crown.
●
Loosen the ring nut 2 using the ring nut
wrench 3 .
Ring nut wrench:
YU-1268/90890-01268
●
Tighten the ring nut 4 using ring nut
wrench 5 and turn the steering right and
left a few times.
NOTE:
Set the torque wrench to the ring nut wrench
so that they form a right angle.
Ring nut wrench:
YM-33975/90890-01403
T
R
.
.
Ring nut (initial tightening):
38 Nm (3.8 m • kg, 27 ft • lb)
2
3
5
4
STEERING HEAD INSPECTION AND ADJUSTMENT