Yamaha TT-R230Y, Руководство пользователя

Страница: 39 / 74

PERIODIC MAINTENANCE AND ADJUSTMENT
7
7 - 9
Tightening torques:
Engine oil drain bolt:
43 Nm (4.3 m.kgf, 3.1 ft.lbf)
Oil filter element drain bolt:
10 Nm (1.0 m.kgf, 7.2 ft.lbf)
13.Refill with the specified amount of
the recommended engine oil, and
then install and tighten the engine
oil filler bolt.
Recommended oil:
See page 9-1.
Oil quantity:
Without oil filter element removal :
1.0 L (1.06 US qt, 0.91 Imp.qt)
With oil filter element removal:
1.10 L (1.16 US qt, 0.97
Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust
system have cooled down.
ECA11620
NOTICE
z z
z z
z
In order to prevent clutch
slippage (since the engine oil
also lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel
specification of “CD” or oils of a
higher quality than specified. In
addition, do not use oils labeled
“ENERGY CONSERVING II” or
higher.
z z z z z
Make sure that no foreign mate-
rial enters the crankcase.
14.Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off and
check for the cause.
15.Turn the engine off, and then check
the oil level and correct it if
necessary.
ECA11230
NOTICE
z z
z z
z
After changing the engine oil,
make sure to check the oil
pressure as described below.
z z
z z
z
Remove the bleed bolt.
z z
z z
z
Start the engine and keep it
idling until oil flows out. If no
oil comes out after one minute,
turn the engine off immediately
so it will not seize. If this occurs,
have a Yamaha dealer repair the
vehicle.
z z z z z
After checking the oil pressure,
tighten the bleed bolt to the
specified torque.
1. Bleed bolt
Tightening torque:
Bleed bolt:
7 Nm (0,7 m.kgf, 5,0 ft.lbf)
Cap_7-15.pmd 3/2/2009, 09:27 9