6 - 3
OPERATION AND IMPORTANT RIDING POINTS
6
EAU16850
Engine break-in
There is never a more important period
in the life of your engine than the first
20 hours of riding. For this reason, you
should read the following material
carefully.
Since the engine is brand new, do not
put an excessive load on it for the first
20 hours of operation. The various parts
in the engine wear and polish
themselves to the correct operating
clearances. During this period, prolonged
full-throttle operation or any condition that
might result in engine overheating must
be avoided. However, momentary full-
throttle operation under load (i.e., two to
three seconds maximum) does not harm
the engine. Each full-throttle acceleration
should be followed with a substantial rest
period for the engine. To allow the engine
to cool down from the temporary buildup
of heat, cruise at a lower engine speed.
0-10 hours
z
Avoid prolonged operation above
1/2 throttle.
z
After every hour of operation, stop
the engine, and then let it cool for
five to ten minutes.
z
Vary the engine speed from time to
time. Do not operate the engine at
one set throttle position.
10-20 hours
z
Avoid prolonged operation above
3/4 throttle.
z
Rev the engine freely through the
gears, but do not use full throttle at
any time.
After break-in
Avoid prolonged full-throttle operation.
Vary the engine speed occasionally.
ECA10270
NOTICE
If any engine trouble should occur
during the engine break-in period,
immediately have a Yamaha dealer
check the vehicle.
EAUW0603
Parking
When parking the vehicle, stop the
engine, push the ignition switch to set it
to “OFF”, and then turn the fuel cock
lever to “OFF”.
EWA10311
z
z
z
z
z
Since the engine and exhaust
system can become very hot,
park in a place where
pedestrians or children are not
likely to touch them and be
burned.
z
z
z
z
z
Do not park on a slope or on soft
ground, otherwise the vehicle
may overturn, increasing the risk
of a fuel leak and fire.
z
z
z
z
z
Do not park near grass or other
flammable materials which
might catch fire.
Cap_6-15.pmd
29/1/2009, 11:30
3
Содержание TT-R230Y
Страница 9: ...LOCATION OF IMPORTANT LABELS 1 1 2 Cap_1 15 pmd 29 1 2009 10 21 2 ...
Страница 27: ...FORYOUR SAFETY PRE OPERATION CHECKS 5 5 2 Cap_5 15 pmd 2008 06 04 07 59 2 ...
Страница 34: ...7 4 PERIODIC MAINTENANCE AND ADJUSTMENT 7 Cap_7 15 pmd 3 2 2009 09 27 4 ...
Страница 69: ...CONSUMER INFORMATION 10 10 5 Cap_10 15 pmd 29 1 2009 12 18 5 ...