52
TROUBLESHOOTING
12 – 15
The volume level cannot
be increased, or the
sound is distorted.
The component connected to the REC OUT
jacks of this unit is turned off.
Turn on the power to the component.
The effect and surround
sounds cannot be
recorded.
It is not possible to record the effect and
surround sounds by a recording component.
A source cannot be
recorded.
An analog source is being input during digital
recording.
Input a digital source.
The settings of the SET
MENU and some other
settings on this unit
cannot be changed.
“9 MEM. GUARD” in the SET MENU is set
to ON.
Select OFF.
This unit does not
operate properly.
The internal microcomputer has been frozen by
an external electric shock (such as lightning or
excessive static electricity) or by a power
supply with low voltage.
Disconnect the AC power cord from the outlet
and then plug it in again after about 30 seconds.
The sound is degraded
when listening with
headphones connected
to a tape deck or CD
player that is connected
to this unit.
This unit is in the standby mode.
Turn on the power of the unit.
There is noise
interference from digital
or high-frequency
equipment, or the unit.
Move the unit further away from such
equipment.
—
—
—
Refer to
page
The unit is too close to the digital or high-
frequency equipment.
Problem
Cause
Remedy
31
39
—
A source component and recording
component are not digitally connected to the
unit.
Make digital connections.
A digital source is being input during analog
recording.
Input an analog source.
A source component and recording
component are not analog connected to the
unit.
Make analog connections.
RX-V520 only
RX-V520 only
RX-V520 only
RX-V520 only
0110V520/V420_50-58_EN
2/6/1, 2:40 PM
52