1
3
2
5
4
Quick Start Guide
GB
Unpacking
Hardware Connection – Computer
System Requirements
LED Indicators
Creating a Powerline Network Using the Pair Buttons
1. Minimum 2 x AC 100V ~ 240V power outlets
2. RJ-45 Ethernet Cable x 2
3. Standard home power wiring
4. A computer with the following:
Operating System with TCP/IP installed
Pentium III compatible processor and above
Ethernet LAN card installed with TCP/IP protocol
64 MB RAM or more
50 MB of free disk space (minimum)
To connect a computer to the Powerline Adaptor, you must use an Ethernet
(RJ-45) cable (included).
Powerline Adaptor x 2
RJ-45 Ethernet Cable x 2
Remove all packaging from the unit. Retain the packaging.
If you dispose of it please do so according to any local regulations.
SSPL500
500Mbps Ethernet Powerline Adaptor
QSG-SSPL500-130201V1
Thank you
for purchasing your new Sandstrøm 500Mbps Ethernet Powerline
Adaptor.
We recommend that you spend some time reading this instruction manual in order that
you fully understand all the operational features it offers. You will also find some hints and
tips to help you resolve any issues.
Read all the safety instructions carefully before use and keep this instruction manual for
future reference.
1. Press and hold the Pair button of Powerline Adaptor A for 3-8 seconds
then release, the Power indicator will start flashing.
2. Press and hold the Pair button of Powerline Adaptor B for 3-8 seconds then
release, the Power indicator will start flashing.
3. Wait for about 1 minute while your Powerline Adaptors A and B are
connecting. The Power indicator on both Powerline Adaptors will stop
flashing and will light up
solidly when the
connection is
successful.
Item
Color
Status
Indication
Power LED
Green
Solid
The adaptor is on.
Blinking
The adaptor is power saving mode.
The adaptor is pairing procedure.
The adaptor is off.
The adaptor is leaving a powerline network.
The adaptor is resetting to its factory defaults.
Powerline
LED
Green
On
Off
Off
Off
Connection rate is more than or equal to 80Mbps.
Amber
Connection rate is between 20Mbps and 80Mbps.
Red
Connection rate is less than or equal to 20Mbps.
Green/Amber/ Red
Blinking The adaptor is transferring data.
The adaptor isn’t connected to any powerline network.
Ethernet
LED
Green
Solid
The Ethernet port is connected, but there is no data being
transferred.
Blinking The Ethernet port is transferring data.
The Ethernet port isn’t connected.
Connect to
Mains Socket
Connect to
Adaptor’s
Ethernet port
Ethernet
Cable
Connect to computer’s
Ethernet port
Powerline
Adaptor A
Powerline
Adaptor B
Powerline
Adaptor C
WAN
WAN
1
WAN
2
3
4
Internet
The Pair buttons must be pressed within 2 minutes of each other.
SSPL500_QSG_7L_130201_Chris.pdf 1 1/2/13 8:55 PM
